Transom Mounting
VERTICAL POSITIONING
1. Place a straight edge on the bottom of the hull directly below
and centered from the desired mounting location. The lowest
point of the Power-Pole anchor must be at least 4” above this
straight edge or the vessel may experience adverse handling
effects. (
FIG. 1
)
NOTE:
If the vessel is equipped with trim tabs that measure 9”
or less in length, the standard 4” minimum mounting
height will be sufficient. If the trim tabs are larger than
9”, the Power-Pole anchor will need to be mounted
higher up on the transom to prevent interference.
2. While holding the Power-Pole anchor in place, turn and tilt the motor as far as possible toward the unit. With
the motor turned toward the unit, manually move the anchor through its entire range of motion to verify
clearance.
3. Once clearance has been verified on the exterior portion of the vessel, check for adequate space on the inside
of the transom mounting area. Make sure that the bolts will not have any obstructions and that you will have
space to tighten the 5/16” tall brass nuts
D
.
Adapter Plate Mounting
1. Please contact one of our authorized dealers or visit
www.power-pole.com
and click on “Find your Adapter
Plate.” For technical support call
1+ (813) 689-9932 option 2
.
Figure 2
1. Place the stern bracket against the transom, mark the
mounting hole locations and drill with a 5/16” drill bit.
2. Apply a liberal amount of marine grade sealant between
the stern bracket and the hull, as well as around the 5/16”
holes.
3. With a 1/2” wrench and 1/2” socket, fasten the stern
bracket to the transom using (4) 5/16” x 3.5” all-thread
transom mount bolts
A
, (4) 5/16” neo-bond washers
B
(4) 5/16” fender washers
C
, and (4) 5/16” tall brass nuts
D
. The rubber backed neo-bond washers
B
will protect
the powder coated surface of the stern bracket and they
must not be over tightened. (
FIG.2
)
IMPORTANT:
Unit must be through bolted to transom.
4”
Figure 1
STEP
1
Choose A Mounting Location
STEP
2
Mounting The Anchor
A
A
D
C
B
B
www.power-pole.com
Содержание Blade
Страница 1: ...INSTALLATION MANUAL ...
