POWXG7214
EN
Copyright © 2021 VARO NV
P a g e
|
7
www.varo.com
7.7
Handle assembly
▪
Fix the handle panel with screw and washer (Fig. 7A-B)
▪
Fix the handle on to the unit body with screws, nut and bolt (Fig. 7C-7F)
7.8
Adjusting the handle height
▪
Move the handle up or down. There are 3 adjustment heights.
▪
Fix the handle with the bolt and locking knob (Fig. 8A-8C)
▪
And attach the cable clamp to the handle (Fig. 8D-8E)
8
CONTROLS
8.1
Engine switch
▪
The engine switch must be in the
“
” position when starting the engine.
▪
Press the switch to
the “
” position to stop the engine. (Fig. 9)
8.2
Choke throttle lever
▪
When starting cool engine, turn throttle choke lever to
“
” position.
▪
When starting warm engine and operating, turn throttle chock lever to
“
”position. (Fig.
10)
9
BEFORE OPERATION
9.1
Add or check oil level
Remove the oil filter cap/dipstick and wipe it clean.
Insert the oil filler cap/dipstick into the oil filler neck, but do not screw it in, then remove it to
check the oil level.
If the oil level is near or below the lower limit mark on the dipstick, fill with 4-stroke
automotive detergent oil SAE10W-30 to the upper limit mark. Do not overfill.
Reinstall the oil filler cap/dipstick.
9.2
Add fuel to fuel tank
Remove the fuel tank cap
Use unleaded gasoline or E10 fuel
Use a suitable funnel to fill in the fuel to the engines fuel tank . Do not spill any fuel or overfill
the tank.
