Power Plus POWX1110, Руководство пользователя

Страница: 6 / 10

POWX1110
EN
Copyright © 2015 VARO
P a g e | 6
www.varo.com
7 ADJUSTMENTS/SETTINGS
7.1 Remove the blades (Fig. 1)

Place the tool on a table with the base plate pointing towards you.

Press and hold the spring-loaded protective cover, and unscrew the 3 installation bolts
with the spanner provided.

Slide the blade out of its holder.
If one of the blades is damaged, always replace both blades.
7.2 Install the blades (Fig. 2)

First clean out all chips or foreign material adhering to the drum(a) or blades(b)

Always replace blades with same dimension and weight.

Slide the blade into the blade
holder. The blade must be level with the planer’s base plate
The blade must be positioned exactly in the middle of the blade holder.

Tighten the 3 installation bolts.
Always unplug the tool before replacing the cutters.
7.3 Setting the planing depth (Fig. 3)

Prior to any assembly and adjustment always unplug the tool.

Plane depth is variable from 0 to 3.0 mm. This is adjustable by rotating the adjustment
knob of cutting depth (2).

As the knob is rotated clockwise from the
“0” position the cutting depth will increase from 0
to as much as 3.0 mm.

It is recommended that test cuts are made in scrap wood after each re-adjustment to
make sure the desired amount of wood is being removed by the planer.

Several shallow passes will produce a smoother finish than one deep pass.
7.4 Mounting and setting the parallel guide (Fig. 4)

The parallel guide assembly is for use when you wish to plane parallel to the work piece.

Secure the parallel guide holder to the left-hand side or right-hand side of the planer using
the wing screw .
 Now secure the parallel stop guide rail “T” to the holder using the wing screw and the
knob. The guide rail must always point downwards.

Set the required distance between the guide rail and the work piece.

Tighten the knob on the guide rail.
8 OPERATION
8.1 Switching on and off (Fig. 5)

Before engaging the on/off switch, check the blades are fitted properly.

Connect the plug to the power supply

To switch on the planer, press the lock-on button (5) and push the ON/OFF switch trigger
(4).

When you release the ON/OFF switch trigger, the machine turns off.
8.2 Drive belt replacement (Fig. 6a, 6b)

Remove the belt cover (7) by unscrewing the 3 installation bolts.

Wear gloves, turn the driven pulley by one hand slowly and pull the belt out by another
hand until the belt fallsl out of the pulley.

To install the belt proceed in reverse order.