POWE40030
EN
Copyright © 2020 VARO
P a g e
|
6
www.varo.com
▪
You can be sure to find the right sandpaper among our product range (see accessories).
WARNING: When removing the sanding paper, follow the above procedure
in reverse order.
WARNING: The sand paper must be stick firmly on sanding plate and
should not come loose.
Never use the machine for sanding magnesium work piece.
7.5
Using the dust bag (Fig. 5)
7.5.1
To install:
Insert the dust bag (4) into dust extraction port (a), rotate the dust bag anti-clockwise by hand
and lock on the correct position, make sure the dust bag is tightly fastened.
7.5.2
To remove:
When removing the dust bag, follow the above procedure in reverse order.
WARNING: Never use the machine for sanding magnesium work piece.
8 GENERAL OPERATING INSTRUCTIONS
▪
Turn on the sander using the ON/OFF switch trigger (2).
▪
Run the sander for a few seconds before contacting the workpiece.
▪
Contact the workpiece with minimal pressure. If the sander is not removing enough
material, try a grittier piece of sandpaper. If you want to remove a lot of material fast, use a
belt sander.
Note: All orbital sanders leave sanding marks on the workpiece. To
minimize sanding marks, always try to sand with the grain of the wood.
▪
Occasionally check the sandpaper for tears, wear, or fraying. Replace if necessary.
▪
When you are finished, turn off the switch.
▪
Allow the tool to come to a complete stop before setting it down.
▪
To prevent accidents, turn off the tool and disconnect its power supply after use. Clean
and then
store the tool indoors out of children’s reach.
