The battery used in the Power-Ped e-Bike is a sophisticated Lithium 36 Volt 11.6Ah hi
capacity battery that requires charging after each and every use.
Charging will take between 6-8 hours from a fully discharged state
Battery Charging Procedure—Important
1. Ensure you have the correct Approved Battery Charger charger.
2. SANS 2 Amp Charger Model SSLCO84V42 or HP Model 8204 3 amp
Lithium Charger.
2. Ensure switch at the power point is OFF.
3. Plug in the charge connector from the battery charger into the charge
power socket located on the rear of the battery. See Below
4. Turn ON the battery charger on at the wall switch.
5. The charger LED Light will be Red when Charging, Green when fully
charged
6. Once charged (Green) the charging lead can be disconnected from the
bicycle. Note:The charging lead can be left connected without harming
the battery. This stage is referred to as TRICKLE charging.
7. It is recommended to turn off the switch at wall when charger is not in use
to ensure you are not wasting electricity and to be ready for the next
charge cycle.
8. Remember to charge after every use regardless of how long the bicycle
was used for. This will assist a longer overall battery life.
9. Note if the vehicle is not being used for an extended period we
recommend charging every 2 weeks.
10.The battery can be charged on or off the bicycle.
Warnings
Mount charger on a wall close to the bicycle. Have power points installed by a licensed Electrician.
Do not expose the battery or battery charger to moisture.
Do not leave charger on the ground where it can be damaged or misused.
Do not expose to excessive heat such as direct sunlight.
Do not cover charger. The battery charger needs to be well ventilated.
Do not drop the charger as it has highly sophisticated circuitry and will be damaged if dropped.
Do not move the bicycle with charger plug connected. This will damage the charger port and the charger socket.
Battery Charging
LED light is Red when charging
LED light is Green when charge
is complete
