Power Master PM-DBC-0124F, Руководство пользователя

Страница: 8 / 23

7
Timer for E "h":
Start counting after "E" (timer) function is operating. When O/P current
is under setting value, the 3
rd
dot signal flashes. It will display the total
time of charge after battery has been fully charged. According to the
value, the user can set the perfect charging time for his own battery.
Ex. If the total time is 1 hour, user can then set the value at 1.0.E.
Pre-charging "C":
When battery voltage < setting value, the pre-charge timer starts
counting. Press & hold “Display Key” for 3 seconds while displaying
“C” to enable timer setting (Upper Bar twinkle: increase; Bottom Bar
twinkle: decrease. Each increment or decrement represents 0.1 hour).
Press & hold “Display Key” for 3 seconds to save the new setting
value.
The bottom bar of small letter “c” twinkle means the charger is
charging the battery by 25% of rating current.
The upper bar of small letter “c” twinkle means the charger is charging
the battery by 50% of rating current.
When battery voltage > setting value, the charger will switch to
equalizer charge stage, and LCD Display will show O/P voltage.
Other Settings & Displays
O/P Current Adjustment:
Press and hold "Display Key" for 3 seconds while displaying "P" to
enable O/P current adjustment.
Upper Bar twinkle: Press “Display Key” to increase the value;
Bottom Bar twinkle: Press “Display Key” to decrease the value.
This function is for authorized technicians only.
High Voltage (Over Charging):
If the battery voltage is over setting value, the display will show "H.V."
& "xx.xv" alternately; the small letter “v” (high voltage) is to distinguish
from capital “V” (O/P voltage); meanwhile, the charger will stop
charging & LED off. Press “Display Key” to reset.
Stop Charging:
1. Current < 10% of rating, the display will show “End” & ”x.x h.”
alternately.
a. Chargers without float charge stage will stop charging and
have LED off.
b. Chargers with float charge stage available will switch to float
charging and have green LED on.
2. When over timer setting but current >10% of rating, the display will
show “End” & “x.x E.” alternately.
a. Chargers without float charge stage will stop charging and
have LED off.
b. Chargers with float charge stage available will switch to float
charging and have green LED on.
3. Press “Display Key” to reset
Battery Error:
If the battery voltage cannot rise to the setting value while the setting
time of 25% of rating current pre-charging is over, the display will show
“Err_” & “xx.x v” alternately. This value represents the final battery
voltage. The small letter “v” (final battery voltage) to distinguish from
capital “V” (O/P voltage).