power King PK4516, Руководство по эксплуатации

Страница: 20 / 27

19
Carburetor
L H
T
Do not adjust the carburetor unless otherwise required.
The carburetor is adjusted according to the following steps;
• Low-speed mixing regulator (L): rotate 1 - 1.25 turns.
• High-speed mixing regulator (H): rotate 1.5 - 2 turns.
• Idle-speed regulator (T): rotate the screw to the bottom
mark and then clockwise until the saw chain rotates,
followed by rotation of 1/2 turn.
Warning
Before start, the idle-speed regulator must be adjusted
until the saw chain does not rotate.
Air filter
Air filter
locking nut
H L
H L
Air filter
cover
Air filter
Check it before each use.
Loose the air filter locking nut, remove the air filter cover, and
take out the air filter. Carefully wipe the dust, or clean the air
filter with high-pressure air, or replace the air filter.
Reinstall the air filter and air filter cover, and tighten the air
filter locking nut.
Fuel supply system
Check whether fuel leaks out of the fuel pipe, sealing plug and
fuel tank after fuel filling and before use.
Fire may be caused in case of fuel leakage. Immediately stop the
machine, and contact POWERKING for repair.
Gasoline filter
Check it on a regular basis.
• Prevent the fuel container from
dust.
• If the filter is blocked, the engine
cannot be started easily or rotates
abnormally.
• Take the fuel filter out of the fuel inlet with the iron wire
or similar tools.
• If the filter screen is too dirty, replace it.
• If there is dust in the fuel tank, clean the tank with
gasoline.
Oil Filter
Check it on a regular basis.
• Prevent the oil container from dust.
• If the oil filter screen is blocked,
normal lubrication of the system
will be affected.
• Take the oil filter screen out of
the oil inlet with the iron wire or
similar tools.
• If there is dirt on the filter, clean it with gasoline.
• If there is dirt in the oil tank, clean the tank with gasoline.
Gasoline filter
H L
2
1
4
1
Oil
filter