V4.0
16 in. High-Velocity Barrel Fan
8978561
Visit www.princessauto.com for more information
7
IDENTIFICATION KEY
A Drum
B Locking Knob (2)
C Washer (2)
D Rubber Pad (2)
E Stand
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
1. Insert a locking knob (B) through one arm of the stand (E) towards the
inside.
2. Slide a washer (C) onto the locking knob, then the rubber pad (D). Pull the
knob outward until it barely protrudes from the rubber pad.
3. Place the drum (A) onto the work surface with front facing up.
4. Align the bolt hole on the drum’s side with the locking knob. Screw the
knob into the drum.
5. Insert the other locking knob through the remaining arm. Slide the washer
and rubber pad onto the bolt.
6. Screw the locking knob into the bolt hole on the other side.
7. Lift the drum by the handle and place the fan on the work surface. Adjust
the locking knobs to secure the drum in position.
OPERATION
This fan comes fully assembled. No further assembly is required.
To adjust the airflow upward or downward: Tilt the fan head to the desired
angle. This high velocity fan can be used along or in conjunction with air
conditioning. Rotating the fan head upward serves to pull air from the floor and
circulate it throughout the entire room.
1. Use the knob to loosen the tilt nut by turning the knob counterclockwise.
2. Adjust the fan head to the tilt that you want.
3. Tight the tilt nut by turning the knob clockwise.
