V1.0
4 in. Fork Ball Mount
8916793
Visit www.princessauto.com for more information
5
IDENTIFICATION KEY
A
Hitch Ball, 2 in.
B
Frame Sleeve
C
M20 Bolt and Lever
D
Steel Loops
E
Frame Brace
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
1.
Insert the 2 in. hitch ball’s (A) threaded stem through the frame
sleeve’s (B) bolt hole.
2. Secure the hitch ball with the nut.
OPERATION
1.
Make sure the forklift, skid loader or tractor is capable of pulling the
load.
2. Inspect the entire fork for cracks or damage that can cause it to fail
under load. Do not use the fork if damage is found.
3.
Slide the frame sleeve (B) onto a fork until the point is seated in the
frame brace (E).
4.
Tighten the M20 bolt (C) clockwise until it is tight against the fork.
5.
Lower the fork until the hitch ball is just below the trailer hitch.
6. Slowly raise the forks until the trailer tongue is level. Lock the trailer
hitch to trap the hitch ball.
7.
Attach the trailer’s safety chains, remembering to cross each over to
the opposite sides’ steel loop.
8. The trailer is ready for towing. Test the fork ball mount under a light
load to make sure it is firmly installed.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
