V4.0
Transmission Adapter for Floor Jacks
8667891
Visit www.princessauto.com for more information
7
RAISING THE TRANSMISSION
1. Move the transmission jack so that the transmission is lined up properly
with its connection points.
2. Close the release valve on the hydraulic unit. Pump the handle to raise the
transmission jack. Guide the transmission back into place and secure it to
the chassis.
3. Release the chain, then slowly turn the release valve.
4. Allow the saddle to descend an inch and close the release valve. Check that
that transmission is secure. Open the release valve and allow the jack to
fully retract, then remove the jack.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool handles clean, dry and free from oil/grease at all times.
6. Maintain the tool’s labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
LUBRICATION
Inspect and lubricate the tool when required. Only use light oil to lubricate the
tool.
STORAGE
When not in use for an extended period, apply a thin coat of lubricant to the
steel parts to avoid rust. Remove the lubricant before using the tool again.
