8657819
Bench Top Oven
V4.0
8
For technical questions call 1-800-665-8685
2. Plug the oven into an outlet. The oven requires 1,400 watts to function.
Remove any other devices on the same electrical circuit.
3. The tray handle hooks into the tray to allow it to be removed safely while hot.
OPERATION
BEFORE FIRST USE
1. Remove the exterior and interior packaging.
2. Remove the rack and clean the oven interior surface with lukewarm water
and a soft cloth.
3. Burn the protective coating off the heating elements. Only do this in a well
ventilated area to avoid fumes. Also ensure it is away from the powder
coating area to avoid potential explosions.
a. Open the oven door and remove the rack.
b. Set the temperature control to 480 ºF (250 ºC).
c. Select the toast function so both the top and bottom heating elements
are activated.
d. Set the timer for 15 minutes.
e. Allow to cool once the 15 minutes are finished.
CURING THE PART
WARNING! Wear a NIOSH approved activated charcoal respirator when curing
the powder. Ventilating the area is not sufficient to avoid the hazard. Fumes
emitted by the plastic powder may contain isocyanates or other hazardous
chemicals that can cause respitory damage, eye and skin irritation or
create an allergic sensitivity to a chemical. Consult the SDS for the powder.
There are several options for curing. All require that the part can be heated to
400 °F (205 °C) for an average of 15 minutes. Check the powder’s instructions
for temperature and time.
Another method is to keep an eye on the part. The coating will melt and a sheen
will develop. When the part is entirely covered with a sheen, keep heating for
another 10 minutes.