Power Fist 8549776, Руководство пользователя

Страница: 8 / 32

8549776 1/4 in. Air Hydraulic Riveter V 4.1
8 For technical questions call 1-800-665-8685
OPERATION
1. Tighten the pin cap nut (#10) to the secure the pin cap (#9).
IMPORTANT! Position the slot of the pin cap (#9) to face upward to avoid
spilling the used rivet pins.
2. Select the appropriate size nosepiece to match the rivet’s pin used and
install following the instructions in the nose piece section.
IMPORTANT! When drilling holes in the work piece for the rivets, it is
important to use the same diameter of drill bit as the outer diameter of the
rivet you will be using.
3. Connect the air hose from the air compressor to the quick connector of the
air hydraulic riveter.
4. Turn on the air compressor. The regulator should be set to 90 PSI.
WARNING! Do not exceed 90 PSI.
5. Insert the small end of the selected rivet fully through the nosepiece.
WARNING! Keep fingers and objects away from the trigger (#26) when
inserting rivets.
6. Insert the rivet into the predrilled hole in the workpiece.
7. With both hands, firmly grasp the riveter and squeeze the trigger (#26) to activate
the tool. If necessary, repeat the procedure of squeezing the trigger (#26).
8. Once the rivet has been fastened, release the trigger (#26).
9. Once you have finished using the air hydraulic riveter, turn off the air
compressor. Squeeze the trigger to relieve any pressure that may be caused
by compressed air still in the riveter. Disconnect the air hose from the riveter
and store the riveter in a cool, dry place, out of the reach of children.