Air Reciprocating Saw
13
Visit www.princessauto.com for more information
8435992
V 2.1
TROUBLE SHOOTING
If the tool does not function properly or if it is missing parts, contact Princess Auto Ltd. for a solution. If unable to
do so, have a qualified technician service the tool.
Problem(s)
Possible cause(s)
Suggested solution(s)
Tool runs at normal speed
but loses power under load.
Motor parts worn.
Have a qualified technician replace worn parts.
Lack of air tool oil.
Pour air tool oil into air inlet per instructions.
Tool runs slowly. Air flows
slightly from exhaust.
Motor parts jammed with
dirt particles.
OR
Air flow blocked by dirt.
Check air inlet filter for blockage.
Pour air tool oil into air inlet as per instructions.
Operate tool in short bursts.
Disconnect air supply. Free motor by rotating drive
shank manually where applicable.
Repeat above as needed. If this fails, bring to
Princess Auto Ltd. or to a qualified technician.
Excessive air tool oil in tool.
Run tool under no load for short periods of time
until exhaust clears.
Buildup of shipping grease.
See Removing Packing Grease section.
Air Flow Regulator is in the
closed position
Open regulator to correct position
Tools will not run. Air flows
freely from exhaust.
O-rings throttle valve
dislodged from seat
inlet valve.
Have a qualified technician replace the O-ring.
Damage or excessive
wearing of internal parts.
Bring to Princess Auto Ltd. or a qualified technician.
Material buildup impeding
motor vanes.
Clean internal mechanism.
Tool will not shut off.
O-rings throttle valve
dislodged from seat
inlet valve.
Bring to Princess Auto Ltd. or a qualified technician.
Loss of power or
erratic performance.
Excessive drain on the air
line. Moisture or restriction
in the air hose. Incorrect size
or type of hose connectors.
Check the air supply. Ensure tool is connected to
a 3/8 in. I.D. or larger air hose with no kinks or
restrictions and that the fittings are connected
properly.
Air compressor has
insufficient flow.
Ensure tool is connected to a compressor with a
rated flow that matches the tool.
