20 pc Wall Mount Storage Bins
2
For technical questions call: 1-800-665-8685
8387722
V 2.0
INSTALLATION INSTRUCTIONS
WARNING! Read the entire important safety information section at the beginning of this document including all
text under subheadings therein before set up or use of this product.
INSTALLATION
1. To hang the Poly Bins and Rails from a wall or workbench,
use a level (not included) to draw an even line.
2. Put Rails against the desired mounting surface and mark mounting
hole positions.
3. Use a drill to set the path for each Screw. Make certain that the
drilling path for the Screw is clear and free of obstacles such as
wires, cables and lines. Use wall anchors (not included) as necessary.
Insert screws through holes in the Rail and into a stud. Make certain
to insert a screw through every hole in the Rail. If not fully and adequately screwed into the stud the Rails
and Bins will pull away from the wall, damaging the Bins and Rails and creating a hazard.
4. Once the Rail is fully anchored to the wall, place the tabs at the top of each Bin over the lip of the Mounting
Rail as shown in Figure 1.
UNPACKING
1. Carefully remove the parts and accessories from the box.
2. Make sure that all items listed in the parts lists are included.
3. Inspect the parts carefully to make sure the tool was not damaged while shipping.
4. Do not discard the packaging material until you have carefully inspected and satisfactorily operated the tool.
WARNING! If any part is missing, do not operate the tool until the missing parts are replaced. Failure to do so
could result in serious personal injury.
CLEANING AND MAINTENANCE
1. Before each use, inspect the condition of the Bins and Peg Panel Board (3). (See Fig 1.)
a. Check for cracks and splits or any other broken part.
b. Make sure the Peg Panel Board has not loosened from the wall.
2. When necessary, clean the Bins with a damp cloth or shop towel.
