Adjustments
Adjustable stationary vise
The adjustable stationary vise is located on the base of your cut-off saw.
This vise can be rotated to attain cutting angles from 0 to 45 degrees and
moved rearward to allow greater cutting widths.
Warning : Always unplug the saw from power source before making
adjustments or performing routine maintenance. Failure to heed
this warning can result in serious personal injury.
Cutting angle adjustments
To adjust the angle of cut:
1. Using the supplied wrench, loosen hex head bolts behind the fence;
2. Rotate the vise fence until the desired angle of cut is aligned with the
indicator groove in the saw base.
3. Check the angle of the vise fence to the abrasive wheel using a
protractor, bevel square, or similar devise.
4. Using the supplied wrench, securely tighten hex head bolts holding the
vise to the saw base.
Moving the stationary vise
To increase the width of cut of the cut-off saw:
1. Using the supplied wrench, remove hex head bolts securing the vise to
the cut-off saw.
2. Reposition the curved slot of the vise base with the most rearward
threaded hole in the saw base to install a hex head bolt in this hole. DO
NOT TIGHTEN.
3. Align the remaining vise bolt hole with the middle threaded hole in the
saw base. Install a hex head bolt.
4. Check or adjust the cutting angle and securely tighten both hex head
bolts with the supplied wrench.
8069627 manual 3/29/05 5:04 PM Page 7
