79 pc Rotary Tool and Accessory Kit
12
For technical questions call: 1-800-665-8685
8336851
V 2.7
INSTALLING ACCESSORIES
1. Turn the switch OFF and disconnect the tool from the
power source.
2. Depress the spindle lock button (1) and slowly turn the collet
nut (2) until the spindle lock button locks the spindle.
3. While holding the spindle lock button down, turn the collet nut
counter clockwise until the collet is loose inside the collet nut.
4. Insert the accessory (3) into the collet.
NOTE: Make sure the correct collet is used for the accessory.
If the collet is too large, replace the collet with the next smaller
size.
5. Insert the accessory 3/4 in. into the collet.
6. Press the spindle lock button and engage it in the spindle. While holding the spindle lock button
down, hand-tighten the collet by turning it clockwise.
NOTE: Do not use pliers to tighten the collet nut. Use the small wrench (4) supplied. Over
tightening will cause damage to the tool.
7. Pull on the accessory to ensure that it is securely in place.
OPERATION
ON / OFF SWITCH
To turn the switch ON, push on the lower part of the ON / OFF switch
(1) (See Figure 4). To turn the switch OFF, push on the upper part of the
ON / OFF switch (2).
Fig.2
Fig. 4
Fig.3
SPEED SELECTION
Set the rotary tool speed by rotating the variable speed control dial (1)
to the appropriate speed (See Figure 3). Position the speed control
dial at "1" for slowest speed, "3" for medium speed and "MAX" for the
highest speed.
