1.6 GPM @ 2,000 PSI Electric Pressure Washer
8
For technical questions call 1-800-665-8685
8465437
V 3.01
PRESSURE WASHER MAINTENANCE
This pressure washer features a closed lubrication system, so no addition of oil is required.
WARNING ! Ensure the pressure washer is disconnected from power source and water supply and that the
system is depressurized before doing any of the following maintenance.
1. Disconnect high-pressure hose (#9) from the unit and from the spray gun (#6).
2. Disconnect garden hose from the pressure washer.
3. Remove excess water from the pump by tipping the unit on both sides to drain any remaining water from
inlet (#16) and outlet (#1) fittings.
4. Remove water intake filter and flush with water to remove dirt or debris. Return filter once cleaned.
5. Drain detergent bottle and flush with running water.
6. Wipe away any remaining water on all parts and fittings.
7. Engage the trigger lock.
STORAGE
If you must store your pressure washer in a place where temperature is below 5°C (41°F), you need to apply
winterizing procedure to protect it. Failure to do so may permanently damage the pump.
Optimum Winterizing Procedure
NOTICE: Using pump saver, available at Princess Auto, will keep the internal parts lubricated, protected from
rust and prevents the pump from freezing.
1. Disconnect pressure washer from power source and water supply.
2. Connect the pump saver hose to water inlet (#16).
3. Depress button on pump saver container.
4. Continue until fluid exits the pump outlet (#1).
5. Remove the hose from water inlet.
Alternative Procedure
If you cannot perform the optimum winterizing procedure, you can still protect your pressure washer
from winter damage:
1. Disconnect all water connections.
2. Turn on the unit for a few seconds. Squeeze trigger to bleed any remaining water in the pump.
Tum off immediately.
NOTICE: Continued use of the pressure washer without a water supply will cause severe damage
to the pump.
3. Remove the gun (#6) and hose (#9) from the pressure washer. Drain any excess water. Roll hose carefully
and do not allow it to become kinked.
4. Store the unit and accessories in a room that does not reach freezing temperatures. Do not store near
furnace or other heat sources of heat as it may dry out the pump seals.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
