Air Body Saw
6
For technical questions call: 1-800-665-8685
8164691
V 2.0
9. Avoid using too long of an air hose. The longer the hose, the lower the pressure will be at the end of the
hose, to the point that it may not meet the minimum required for the tool. As well, a longer hose can
become a tripping hazard.
10. Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain that all
connections are secure.
11. Always carry a tool by its handle, never carry the tool by the air hose.
12. Line pressure should be increased to compensate for unusually long air hoses (over 26 ft). The hose
diameter should be 3/8” l.D.
13. Air tool CFM consumption ratings are based upon a 25% duty cycle. If you require continuous duty, a larger
compressor will be required (eg. 4.0 CFM tool at continuous duty requires 16.0 CFM to function at
maximum torque).
AIR SOURCE INSTALLATION
1. Set the air pressure regulator on the air compressor to 90 PSI. Do not exceed the tool’s recommended air
pressure. Excess pressure could result in damage to the tool, to your work piece or serious injury.
2. Prepare a standard 1/4” air connector for use with your tool. Wrap the threaded portion of the air connector
with thread tape. Attach it to the tool’s air inlet. Tighten securely.
3. Attach a standard quick connector to the air source’s hose. Attach the air hose to the tool.
Note: If you are not using an in-line oiler, add a few drops of air tool oil in the tool’s air inlet before use. In
the same manner, add a few drops after every hour of use.
4. Check the airline and its connections for air leaks. Do not use this tool until you have repaired all air leaks.
Note: Turn off the air compressor, disconnect the air pressure hose and discharge any residual pressure
inside the tool before changing accessories or making any adjustments to the tool. Failure to do so could
result in severe injury, tool or property damage.
UNPACKING
1. Carefully remove the parts and accessories from the box.
2. Make sure that all items listed in the parts lists are included.
3. Inspect the parts carefully to make sure the tool was not damaged while shipping.
4. Do not discard the packaging material until you have carefully inspected and satisfactorily operated the tool.
WARNING! If any part is missing, do not operate the tool until the missing parts are replaced. Failure to do so
could result in serious personal injury.
OPERATION
PARTS IDENTIFICATION
Air Inlet (9)
Pivot Point of
Throttle Lever (13)
Throttle Lever (13)
Throttle Safety
Blade Guard (34)
Blade (35)
FIGURE 1
