TROUBLESHOOTING
PROBLEM INDICATOR
STATUS
SOLUTION
No sound
Red transmitter position.
indicator is not flash
Slide transmitter POWER ON/OFF switch to ON
Make sure battery is Inserted properly, observing battery
("+/."). If battery is inserted
properly. replace with fresh battery.
No sound
Red transmitter indicator Is flash
Slide transmitter MUTE/ON switch to ON position
No sound
Red receiver POWER light off.
Make sure ac adapter is securely plugged into electrical
outlet and into de input connector. Make sure ac
electrical outlet works and supplies proper voltage.
No sound
Receiver signal Indicators A/B
lights glowing
Turn up receiver volume control. Confirm that the output
connections from the receiver to the external equipment
are secure.
No sound
Receiver signal Indicators A/B
lights off, Transmitter and
receiver POWER lights glowing
Confirm transmitter’s and receiver’s frequencies match.
Move transmitter closer to receiver
Sound level differs
from level of a
cabled instrument
Receiver signal Indicators A/B
lights glowing
Adjust transmitter gain level to compessary
Adjust receiver volume as necessary
Sound level differs
with different guitars
Receiver signal Indicators A/B
lights glowing
Readjust transmitter gain level to compensate for
differences In guitar outputs
Distortion level
Increases gradually
Receiver Signal Indicators A/B
Lights and transmitter LOW
BATTERY light glowing
Replace transmitter battery
Bursts Of noise or
other audible radio
signals present
Signal Indicators A/B lights on
Identify potential sources of interference (other
RF·sources) and turn off, remove or use a wireless
system operating on a different frequency
Momentary loss of
sound as transmitter
is moved around.
performing area.
Receiver signal Indicators A/B
lights off when sound is lost
Reposition receiver and perform walkthrough test, if
audim dropouts persist mark "dead" spots and avoid
them during performance
SYSTEM SPECIFICATIONS
RF Carrier Frequency Range ..................... Approximately 791 to 812 MHZ
(Available freq. depend on applicable regulations in country where system is used).
Operating Range...........................................50m (under typical conditions)
Audio Frequency Response.........................................50Hz to 15kHz,±3dB
THD....................................................................................................... <1%
Operation temp. range ........................................................... -29°C to 74°C
..................................................NOTE:Battery characteristics may limit this
1622