Jigsaw operation
Assembling saw
To assemble the saw, proceed as follows:
1. Loosen the two socket head screws at the front with the Allen key
supplied.
2. Place the saw in the saw buckle (6). Make sure that the teeth point
upwards and forward. The smooth side of the saw must rest against the
wheel.
3. Push the saw as far into the buckle as possible.
4. Secure the saw by tightening the two socket head screws again.
Make sure that the socket head screws are tightened evenly so that the
saw blade sits correctly in the saw buckle. A crooked blade can result in an
unsatisfactory cut.
Adjusting the bottom plate
Adjust the angle of the bottom plate (3) as follows:
1. Loosen the socket head screw (7) with the Allen key supplied.
2. Move the bottom plate forward slightly to unlock it.
3. Turn the bottom plate to the right or left in the desired sawing angle.
You can read this on the protractor. The maximum sawing angle is 45º.
4. Push the bottom plate backward again to interlock it.
5. Tighten the socket head screw again.
Operation
Start: Depress the on/off trigger (1) and, at the same time, depress the
trigger locking button (2).
Stop: Release the on/off trigger.
UK Helpline 0203-5142281 • Ireland Helpline 1800-719901
Web Support: www.servotool.eu
Model Number: PAC-18/4K
26
CDM6180 Ma-GB-IRE 1108-10.indd 26
8/10/11 10:32:35 AM
