Power Craft 66498, Инструкция по эксплуатации, Страница: 20 / 29

20
NEVER press the safety switch in when the gun is
not in contact with the item! If the gun discharges
nails into the air, it can result in serious injury or
material damage.
Check for concealed power cables, pipes etc in the
items or surface you are going to nail.
Preparation and adjustment
Charging and fitting the battery
Charge the battery (8) fully before using the
machine for the first time.
Press the lock tabs (9) on the sides of the battery
and pull the battery out backwards.
Plug the charger station (12) into the mains and
insert the battery into the station. The battery
cannot be inserted if the poles are incorrectly
aligned.
The red diode will light while the battery is
charging. Charging takes approx. 1 hour. When
charging is complete the green diode will light.
Disconnect the station from the mains and insert
the battery in the nail gun.
Loading nails
Press the magazine release (7) and pull the
magazine (6) out of the gun.
The nail rack (a) and feeder (b) will now be visible.
Insert the required number of nails or staples (10)
in the rack. The points must point downwards and
the feeder should apply pressure from the right.
Replace the magazine. Check that it clicks into
place and cannot be pushed to one side without
pressing the release.
ENGLISH
INSTRUCTION MANUAL
Setting nail depth
Use the depth setting button (2) to adjust the
distance the nail is to be driven into the item. Turn
the button clockwise to increase depth and
anticlockwise to reduce it.
Check the depth is correct on a piece of scrap
wood before using on the item.