Power Climber Wind BAP 360, Инструкция по эксплуатации и монтажу

Страница: 36 / 37

Reference: 38741 Issue date: 2018-JUL-24 Revision: L Page 36 of 37
14. General Caution And Precautions
See European Standard EN1808 for details on Applications that are
excluded from the EN1808 and other relevant exclusions.
TSP = Temporary Suspended Platform
1. Power Supply to the TSP must be fitted with
a) Main switch
b) Residual current device (or earth leakage circuit breaker) of 30 mA
c) Over current protective device (automatic fuse Type C)
Note: check that the specifications of the electrical supply cable match the power requirement of the
platform and will avoid a voltage drop due to cable length.
2. Weather conditions
Temperature range: -10ºC and +55º C
Humidity range: 30 % - 95 %
Contaminants: Degree of protection IP 54
3. Precautions prior to use
a) Before using the equipment, operators must carry out the daily checks and make sure that the
equipment is in perfect working condition.
b) Before use, modular TSP equipment must be checked to prevent mixing of inappropriate
components.
c) Before use, check that sufficient space is available for operating the TSP.
d) Before using the equipment the suspension system must be checked to ensure the stability of
the TSP at all times.
e) In case the area below the TSP is open to the public, preventive measures have to be taken to
safeguard the people below (e.g. barriers, roof protected walkways, etc.).
f) All hazards related to the platform encountering obstructions are not completely covered by the
TSP’s safety devices. The operator shall check for obstructions along the travel of the platform.
g) Overload detection device may not protect TSP platforms in all configurations. The operator
shall check that the loading of the platform is in accordance with the rated load indicated on the
nameplate.
h) An area must be available to allow operators to get on and off the platform.
4. Precautions during use
a) The operators must stop working with the equipment and notify the supervisor if faults, damage
to the equipment or other circumstances may jeopardize safety.
b) A suitable communication between the operator and the supervisor is recommended.
5. Suspension System
a) The platform can be suspended on different types of suspension systems such as roof beams
(with counterweights), parapet clamps, davits, fixed suspension points, custom made
suspension systems, roof rigs made from tubular scaffolding etc.
b) Roof systems to be calculated for a max load of W.L.L. x 3 (Maximum allowable stresses below
yield.)
c) Check that roof beams are properly counterweighted (if applicable).
d) Ensure that the suspension rig is directly above the platform prior to installation.