Power Acoustik PL-51B, Руководство пользователя

Страница: 4 / 16

INSTALLATION
Installation Procedures
Installation Opening
To Install the Car Radio
First complete the electrical connections and then check for correctness.
This unit can be installed in any dashboard Having an opening as shown the right figure.
Be sure you test all connections first, and then follow these steps to install this unit.
1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery’s
negative (-) terminal.
2. Disconnect the wire harness and the antenna.
3. Lift the left or right top corner of the plastic outer trim ring then pull it out to remove it.
4. Insert the two bracket keys into the left and right side of the chassis, as shown the below
figure to separate the chassis from the housing.
5. Insert mounting sleeve into the dashboard and bend the mounting tabs out with a screw-
driver. Make sure that the lock lever is flush with the mounting sleeve and is not projecting
beyond.
6. Insert car radio into the mounting sleeve.
7. Use a metal strap to secure the rear part of the chassis using the hardware indicated.
8. Make wiring connections, as illustrated in the “Wiring Diagram.”
9. Install the plastic outer trim ring.
2
182 mm
53 mm
Bracket key
Bracket key
Plastic outer trim ring