Power Acoustik EG1-10000D, Руководство пользователя

Страница: 3 / 23

lns�alla�ion
lnstallation Notes
The amplifier is generally mounted in the rear trunk area but сап Ье mounted in any convenient area such as beneath а seat.
Please Ье sure to locate this unit where you have reasonaЫe air circulation and protection from moisture. When considering the
mounting location you should minimize the length of the power and speaker leads. Minimizing both leads will yield а more reliaЫe
installation. lt is also important to ensure that the heat sink fins are not against а panel ог а surface, preventing air circulation. Do
not install the amplifier оп а subwoofer Ьох or оп vibrating parts of the vehicle, since the vibrations сап cause damage to the
amplifiers electrical components.
lnstallation of the amplifier
Before starting with the installlation, mount the provided mounting brackets оп the
amplifier. Mark the location for the mounting screw holes Ьу using the amplifier as а
template. Drill holes at the marked locations as and firmly fasten the amplifier in place
with the mounting screws supplied in the accessory kit. Before drilling ог cutting any holes,
investigate the layout of your automoblle thoroughly: Take саге when working near the
gas lines or hydraulic lines and electrical wiring.
Electrical Connection
Ground (GND)
This wire is the electrical ground and must Ье fastened securely to the vehicle chassis. The best method is to use а threading
sheet metal screw since the threads cut into bare metal. Ensure that all paint or other insulationis removed from around the hole
агеа, and using self tapping screw, securely affix the Ьаге wire ends to the vehicle chassis. Use as short а piece of саЫе as
possiЫe - use the same gauge as was used for the +12V саЫе. Make sure that the connection is safe and staЫe.
Remote (REM)
Connect the remote wire of your headunit with the remote turn-on of the power amplifier.
Battery Connection (+12V Power)
This wire is usually connected directly to the positive battery terminal. Ensure that the + power supply wire is fused via an in-line
fuse near Ьу the battery. Please use а sufficient gauge (min 16 mm) with spade lug with insulating sleeve.
Fuses
The integrated amplifier fuses protect the units from short circuit and overload. The fuse rating is for 4 Ohm loads (impedance) of
the speakers, for 2/1 Ohm loads the fuses may have to get increased Ьу up to 50%/100% in case of higher power consumption.
EG2-1400/EG4-1 000/EG4-1500
о
���
о
RemoteWire
(REM)
Connectlon
EG1-10000D
о
� � �
о
о
Ground-Conn�ion
to vehicle's chassis
RemoteWlre
(REMJ
GND
.,.
+12У
Connectlon
EG1-2500D/4500DП000D/EG5-2800
POWERINPUT
о
to vehicle's chassis
о "
Q
t.
г;;;;;J"о;
RemoteWlf'fl
(REMJ
� � �
о
о