background image

     

Drive, Approach and 
Total Distance

Distance Units
Yards / Meters

Default Display

Understanding the Battery Gauge:

The battery gauge on the FW5s is similar to a car fuel gauge - F (full), ½ (half full) & E 
(empty). There are five blue bars and depending on the charge state of your battery 
will determine how many bars illuminate. When a fully charged battery is connected to 
the trolley all five blue bars will illuminate. 

As you progress through your round the blue bars will extinguish from full to empty. 
When the fifth blue bar is extinguished it indicates that the battery is flat. When your 
battery is new you may lose only one or two bars during the entire round. As your 
battery ages, you may lose more bars. 

If you lose all the blue bars this could indicate; (1) you have not fully charged your 
battery (2) your battery is nearing the end of its useful life and you should consider 
buying a replacement.

Automatic Distance Function (ADF):

The ADF function is a convenient way of sending your trolley a set distance. (15, 30, 45 yards 
or meters) For example when you are approaching a green you can send the trolley towards 
the next tee if the route allows. Please note it is not recommended to send your trolley 
unattended over steep or rough terrain. To activate when trolley is in pause mode:

1: Press and hold the central control knob until ‘ADF’ appears on the display

2: Rotate the control knob to select the distance required between 15-45 Yrds/Metres.
 
3: To start the function press the control knob. 

4: To cancel rotate the Central Control Knob to “00” and select by pressing the control knob.

WARNING!

 Before using the ADF function please ensure the route is clear from any

obstacles. To interrupt the distance function when in operation press the on/off
button to stop the motor function.

**Please note ADF distance are approximate based on flat level terrain conditions using a fully charged battery. The overall
distance may be affected by terrain conditions, obstacles or incline, battery power and weight of golf bag5

Right Function Button

 - Press to toggle between Yards and Meters.

USB Charging Port: 

Located on the underside of the handle. Open the hatch to charge 

GPS & mobile devices. The output is rated to 5v/500mA suitable for most USB devices*

Factory Settings

Your new FW5s trolley is ready to use, but there are a number of preferences you can 
change in the programming mode. To enter programming mode:

1: Connect the battery to the trolley.

2: With the trolley powered and the default display shown press and hold both function 
buttons for 3 seconds. The main features on the display will be replaced by the clock 
flashing in the top left hand corner of the display.

3: Press the central control knob to select the time and then rotate to change the value. 
Press the central control knob to confirm the value; and move to the next digit. Repeat the 
process until the time is set as required. When complete the time will flash once again.

*USB output voltage 5v/500mA compatible with most USB portable devices, please check device manufacturers instructions
before use. Powakaddy International Ltd accepts no liability for loss of data or damage from using the charging port with
incompatible device.

Yards / Metres

ADF indicator

ADF Distance

Trip Time Indicator

Total / Trip Distance Indicator

Distance

Left Function Button

Central Control Knob

Right Function Button

Time

Digital Speed Setting

Power Indicator

Distance Measurement

Clock

Competition Mode

Battery Gauge

ON
OFF

Right Function Button

 - Press to toggle between Time,Trip time and Calories.

• 

Time:

 The time is shown in the top left corner of the display. This displays the current time.

To adjust the time see factory settings below.

• 

Trip Time:

 This displays the “on” time of the trolley. This will reset when the battery is

disconnected.

• 

Total Trip:

 This displays the total trip distance travelled during the round. This will reset

when the battery is disconnected.

• 

Calories:

 This feature displays the approx. calories burned during your round of golf.

This total will be reset when the battery is removed.

USB Charging Port: 

Located on the underside of the handle. Open the hatch to charge 

GPS & mobile devices. The output is rated to 5v/500mA suitable for most USB devices*

*USB output voltage 5v/500mA compatible with most USB portable devices, please check device manufacturers instructions
before use. Powakaddy International Ltd accepts no liability for loss of data or damage from using the charging port with
incompatible device.

• 

Approach: 

Use to measure your “approach” distance. Reset your “approach” 

measurement (select “approach” press and hold the left function button to reset) as you 
go past the nearest Fairway Distance Marker. Walk to your ball and subtract the distance 
measured from the marker distance. This will be the required distance to the green.

• 

Total: 

This will show the total distance covered by the trolley. This cannot be reset.

Left Function Button 

- Press to toggle between distance measuring.

Drive: 

Reset before leaving the tee to measure your drive*. To reset press and hold the left 

function button (note this will also reset your approach).      

*Please Note: The drive distance displayed is distance travelled by the trolley under power and may not represent total yards/
metres of shot where playing across water or other terrain obstacles that do not allow travel in a straight line from tee to 
ball. The total distance will also be affected by freewheeling downhill and if the rear wheels slip excessively on wet or loose 
ground.

Power Indicator:

Displays whether power is being applied to
the drive system. (green/red)

The FW7s with latest technology and cutting edge styling has a powerful 230w 
motor and bright colour multi-function LCD display. The trolley includes distance 
measuring functions, a calorie counter and USB charging port.

Digital Speed Setting:

Rotate the central control knob to adjust the speed of the trolley from 0 - 9 when 
the motor is powered on. Press central control knob to pause and resume your 
selected speed.

4: Press the right function button to bring up the ‘comp mode’ setting.

5: Press the central control knob to turn ‘comp mode’ on and off. Please be aware with 
competition mode activated all distance measuring features will be deactivated.

6: Press and hold both function buttons to save and exit after changing any settings. The 
display will then return to the default display.

At any point, press and hold both function buttons to exit the factory settings.

00937-01-08 Freeway Instruction Booklet.indd   4-5

18/01/2018   13:05:49

Содержание FW3S









Отзывы:

Похожие инструкции для FW3S