5
ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety before you attempt to assemble or operate your new snow
thrower. Reading the entire manual will familiarize you with the unit, which will assist you in assembly, operation
and maintenance of the product.
Your new snow thrower has been as sem bled at the factory with the ex cep tion of those parts left unassembled for shipping
purposes. All parts such as nuts, washers, bolts, etc., necessary to com plete the as sem bly have been placed in the parts
bag. To ensure safe and proper operation of your snow thrower, all parts and hard ware you assemble must be tightened
se cure ly. Use the correct tools as nec es sary to ensure proper tightness.
FIG. 1
REMOVE SNOW THROWER FROM CAR TON
1. Remove all accessible loose parts and parts boxes
from carton.
2. Cut down all four corners of carton and lay panels flat.
3. Remove the two (2) screws securing the auger housing
to the pallet and remove additional steel brackets from
skid plate if equipped.
4. Remove all packing materials.
5. Remove plastic ties securing the snow thrower to the
pallet.
6. Remove snow thrower from carton and check carton
thor ough ly for ad di tion al loose parts.
HOW TO SET UP YOUR SNOW THROWER
Store the extra shear bolts and nuts provided in parts bag.
UNFOLD UPPER HANDLE (See Figs. 1-3)
1. Raise upper handle to the operating position.
2. Adjust the handle height to desired position using the
appropriate mounting holes and tighten lower handle
knobs securely.
3. Install the additional carriage bolts and handle knobs
that are supplied in the bag of parts to secure upper
handle to lower handle.
HANDLE
KNOB
LOWER
HANDLE
CARRIAGE
BOLT
UPPER
HANDLE
FIG. 3
HANDLE
KNOB
MOUNTING
HOLES
MOUNTING
BOLT
FIG. 2
CARRIAGE
BOLT
