18
SERVICE AND ADJUSTMENTS
SQUARE HOLE
TRACTOR
TO REMOVE MOWER (SEE FIG. 15)
Mower will be easier to remove from the right side of tractor.
•
Place attachment clutch in “DISENGAGED” position.
•
Move attachment lift lever forward to lower mower to its
lowest position.
•
Roll belt off engine pulley.
•
Remove small retainer spring, and lift clutch spring off
pulley bolt.
•
Remove large retainer spring, slide collar off and push
housing guide out of bracket.
•
Disconnect anti-swaybar from chassis bracket by re-
moving retainer spring.
•
Disconnect suspension arms from rear deck brackets
by removing retainer springs.
•
Disconnect front links from deck by removing retainer
springs.
•
Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
IMPORTANT:
IF AN ATTACHMENT OTHER THAN THE
MOWER DECK IS TO BE MOUNTED ON THE TRAC-
TOR, REMOVE THE FRONT LINKS AND HOOK THE
CLUTCH SPRING INTO SQUARE HOLE IN FRAME.
TO INSTALL MOWER (SEE FIG. 15)
•
Raise attachment lift lever to its highest position.
•
Slide mower under tractor with deflector shield to right
side of tractor.
•
Lower lift lever to its lowest position.
•
Connect front links to mower deck and secure with
retainer springs..
•
Connect suspension arms to rear deck brackets and
secure with retainer springs.
•
Connect anti-swaybar to chassis bracket and secure
with retainer spring.
•
Push clutch cable housing guide into bracket, slide
collar onto guide and secure with large retainer spring.
•
Install belt onto engine pulley.
FIG. 15
SUSPENSION ARMS
RETAINER SPRINGS
(BOTH SIDES)
RETAINER SPRING
ANTI-SWAY BAR
HOUSING GUIDE
FRONT LINK
COLLAR
ENGINE PULLEY
LARGE
RETAINER
SPRING
CLUTCH SPRING
SMALL RETAINER SPRING
BRACKET
DEFLECTOR
SHIELD
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
•
Depress clutch/brake pedal fully and set parking brake.
•
Place gearshift lever in neutral (N) position.
•
Place attachment clutch in “DISENGAGED” position.
•
Turn ignition key to “STOP” and remove key.
•
Make sure the blades and all moving parts have completely stopped.
•
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug.
Содержание PR17542STC
Страница 44: ...44 NOTES...
