9
OPERATION
LH and RH turn triggers -
used to steer the snow thrower.
Drive speed control lever -
used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever -
used to engage power-pro-
pelled for ward or reverse motion of snow thrower.
Auger control lever -
used to engage auger motion (throw
snow).
Discharge chute control lever -
used to change the di-
rec tion the snow is thrown.
Skid plate -
used to adjust height of scraper bar from the
ground.
Toolbox -
used to store spare shear bolts, locknuts and
wrench.
Safety ignition key -
must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button –
used for starting the engine.
Recoil (auxiliary) starter handle –
used for start ing the
en gine.
Primer -
pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
ON / OFF switch -
used to STOP the engine.
Choke control -
used for starting a cold engine.
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
TRACTION
DRIVE
CONTROL
LEVER
DISCHARGE CHUTE
CONTROL LEVER
DRIVE SPEED
CON TROL LEVER
AUGER
CONTROL
LEVER
MUF FLER
TOOLBOX
HANDLE
KNOB
SKID PLATE
CHUTE
DE FLEC TOR
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY VARY
WITH THE ENGINE
ON YOUR UNIT.
Fig. 10
AU GERS
DISCHARGE
CHUTE
CLEAN-OUT TOOL
LIGHT
LH TURN
TRIGGER
DEFLECTOR REMOTE
CONTROL LEVER
MUF FLER
GAS O LINE
FILLER CAP
SAFETY
IGNITION
KEY
CHOKE
CON-
TROL
PRIM ER
RECOIL
(AUXILIARY)
STARTER
HANDLE
ELECTRIC
START BUTTON
ON / OFF
SWITCH
