24
REPLACING BATTERY
WARNING:
Do not short bat tery ter-
mi nals by al low ing a wrench or any other
object to contact both terminals at the
same time. Before con nect ing battery, re-
move metal bracelets, wrist watch bands,
rings, etc.
Positive terminal must be connected
fi rst to prevent spark ing from ac ci den tal
grounding.
1. Lift seat pan to raised position.
2. Disconnect BLACK battery cable fi rst
then RED battery cable and carefully
remove battery from trac tor.
3. Install new battery with terminals in
same position as old battery.
4. First connect RED battery cable to
positive (+) terminal with hex bolt and
keps nut as shown. Tighten securely.
Slide terminal cover over terminal
5. Connect BLACK grounding cable to
negative (-) ter mi nal with remaining
hex bolt and keps nut. Tighten se-
cure ly.
02602
02603
Seat Pan
Keps Nut
Positive
(Red)
Cable
Hex
Bolt
Terminal Cover
Negative
(Black) Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the
backside of the grill.
3. Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. When replacing hood, be sure to re-
connect the headlight wire con nec tor.
01536
Headlight
Wire
Connector
Hood
ENGINE
TO AD JUST THROTTLE CON TROL
CABLE
The throttle control has been preset at the
factory and ad just ment should not be nec-
essary. Check adjustment as described
below before loosening cable. If adjust-
ment is necessary, see engine manual
TO AD JUST CARBURETOR
The carburetor has been preset at the
factory and ad just ment should not be nec-
essary. However, minor ad just ment may
be required to compensate for dif fer enc es
in fuel, temperature, altitude or load. If
the carburetor does need ad just ment, see
engine manual.
TO REPLACE FUSE
Replace with 20 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
