Poulan Pro 961420034 Скачать руководство пользователя страница 7

18

SERVICE AND ADJUSTMENTS

 

CAUTION: Before performing any service or adjustments:

•   Release operator presence control bar.
•   Make sure the blade and all moving parts have com plete ly stopped.
•   Disconnect spark plug wire from spark plug and place wire where it can not come in 

contact with plug.

GEAR CASE
•   To keep your drive system working 

properly, the gear case and area around 
the drive should be kept clean and free 
of trash build-up.  Clean under the drive 
cover twice a season.

•   The gear case is fi lled with lubricant to 

the proper level at the factory.  The only 
time the lubricant needs attention is if 
service has been performed on the gear 
case.

GEAR CASE WITH METAL HOUSING:
•   If lubricant is required, use only Texaco 

Starplex Premium 1 Grease, Part No. 
750369.  Do not substitute.

GEAR CASE WITH PLASTIC HOUSING:
•   If lubricant is required, use only 

ELF 

Multis EP00

.  Do not sub sti tute.

ENGINE

Read the maintenance section of your 
engine manual.

LUBRICATION
Change the oil after the fi rst two hours of 
operation and every 25 hours there af ter or 
at least once a year if the lawn mower is 
not used for 25 hours in one year.  Refer to 
engine manual.

TO CHANGE ENGINE OIL
(SEE ENGINE MANUAL)
•   Be sure lawn mower is on level surface.
•   Oil will drain more freely when warm.
•   Catch oil in a suitable container.
•   For engines without dipstick, re move 

bottom oil drain plug.

•   For engines with oil fi ll cap/dipstick, 

remove bottom drain plug or remove en-
gine oil cap and turn mower on its side.

•   After oil has drained completely, re place 

oil drain plug and tighten se cure ly.

•   Refi ll engine with oil.  Pour slowly.  Do 

not overfi ll.

•   Fill to top of slot inside of fi ller hole or 

to “FULL” line on dipstick on models so 
equipped.  Keep oil at proper level.

AIR FILTER
Your engine will not run properly and may 
be damaged by using a dirty air fi lter. 
Clean the element after every 25 hours 
of operation or every season.  Replace 
the air fi lter every 100 hours of operation 
or every season, whichever occurs fi rst.  
Service air cleaner more often under dusty 
conditions.  See the maintenance section 
of your engine manual.

MUFFLER
Inspect and replace corroded muffl er as it 
could create a fi re hazard and/or damage.

SPARK PLUG
Replace spark plug at the beginning of 
each mowing season or after every 100 
hours of operation, whichever occurs fi rst.  
Set spark plug gap according to engine 
manual specifi cations.

CLEANING

IMPORTANT:  For best performance, keep 
mower housing free of grass build-up and 
trash. Clean the underside of your mower 
after each use.
•   Clean the underside of your lawn mower 

by scraping to remove buildup of grass 
and trash.

•   Clean engine often to keep trash from 

accumulating.  A clogged engine runs 
hotter and shortens engine life. 

•  Keep fi nished surfaces and wheels free 

of all gasoline, oil, etc.

We do not recommend using a garden 
hose to clean your lawn mower unless the 
electrical system, muffl er, air fi lter, and 
carburetor are covered to keep water out.  
Water in engine can shorten engine life.

GRASS CATCHER (IF SO EQUIPPED)
Grass catcher may be hosed with water 
but must be dry when used.

 CAUTION:  Under nor mal usage, the 

catch er material is subject to de te ri o ra tion 
and wear and should therefore be checked 
to ensure compliance with origi nal 
manufacturer specifi cations.

7

SPARK PLUG BOOT

On some models a spark plug boot is 
packed loose in the parts bag.  If your 
model has the boot, install on spark plug 
wire and reconnect spark plug wire to 
spark plug.

TO PRE PARE BATTERY
(ELECTRIC START MODELS ONLY)

NOTE:  Your battery must be charged 
before you can start your lawn mower.

UNITS WITH HANDLE-MOUNTED KEY 
SWITCH ONLY:
•  Con nect battery charger con nec tor 

(male) to harness con nec tor (fe male).

UNITS WITH DECK-MOUNTED BATTERY 
or TRIMPLATE-MOUNTED KEY SWITCH:
•   Disconnect engine connector (male) 

from battery con nec tor (female).

•   Connect battery charger connector 

(male) to bat tery connector (fe male).

ALL UNITS:
•   Plug battery charger into 110 volt A.C. 

outlet.

•   Leave battery charger connected for 24 

hours before starting your engine for the 
fi rst time.

UNITS WITH HANDLE-MOUNTED KEY 
SWITCH ONLY:
•   After charging, disconnect harness 

connector (female) from bat tery charger 
connector (male).

Connect your battery charger to charge 
battery after each use.
IMPORTANT: The engine will not recharge 
your battery.

UNITS WITH DECK-MOUNTED BATTERY 
or TRIMPLATE-MOUNTED KEY SWITCH:
•   After charging, connect engine con nec tor 

(male) to bat tery connector (female).

Your engine has an integral alternator for 
partial charging.  Connect your battery 
charger to charge battery as re quired.

Spark plug

Boot

Battery connector (Female)

Battery 

charger 

connector 

(Male)

Engine 

connector

(Male)

Battery 

charger

DECK-MOUNTED BATTERY

TRIMPLATE-MOUNTED KEY SWITCH

Engine
connector (male)

Battery connector 

(female)

Battery charger

Charger connector 
(male)

Engine 
connector 
(male)

Harness 

connector 

(female)

Battery 
charger

Charger 

connector (male)

HANDLE-MOUNTED KEY SWITCH

IMPORTANT:  The engine alternator will 
not charge a discharged battery.

ALL UNITS:
At the end of the mowing season the 
battery should be charged for 48 hours to 
protect the battery during winter storage.

 

CAUTION:  Always dis con nect the 

en gine connector (male) from the battery 
connector (female) to prevent ac ci den tal 
start ing when trans port ing or stor ing your 
lawn mower after the season.

Содержание 961420034













Отзывы: