Pottinger LION 5000, Руководство оператора

Страница: 13 / 29

0000-gb WarTung_877
GB
MaiNTENaNCE aND sErViCE
- 13 -
Spur wheel - angular gear
- First oil change is after 50 hours of operation.
- Further oil change after 500 hours of operation.
Note:
• Change oil when at operating temperature.
The oil is too viscid when cold. Too much old oil remains stuck
to the gearwheels and because of this any suspended matter
present cannot be removed from the gearing.
Attention combustion danger!
• hot gear
• hot oil
- Check oil level before putting into
operation.
Oil level check
- Park machine horizontally.
L = Ventilating screw:
is removed to enable oil filling.
N = Level screw:
oil level is correct when it reaches the same level as the
screw.
A = Drain plug.
Change speed transmission (middle position)
Amount of oil: 6,5 Liter SAE 90
Angular gears
(left and right)
Amount of oil:
4 Liter SAE 90
Changing the tines
Damaged or worn rotor tines are to be replaced. Observe the
correct fitting position of each rotor tine (see Spare Parts list).
Both screws (SK) are to be glued into place with Loctite 24 or
another equivalent product, and tightened to 290 Nm (29 kpm).
greasing
Drive shaft
- Lubricate drive shaft every 40 hours of operation.
- Take sliding sections apart and grease well.
greasing positions
- after 0 operating hours greases.
FETT