Over the Door Vanity Station
MOUNTING INSTRUCTIONS
Hardware Included:
(4) Anchors (4) Hooks
(4) Screws
(8) Small Bolts
Tools Required:
Phillips Screwdriver, Level, Level
Stud Finder, Tape measure
This item consists of two products - one shelf organizer & one mirror. Each product can be used in either way of
wall mounting by using the two keyholes located on the back of the product, or hanging over a door by using the
provided hooks.
Note:
the maximum load capacity is 10 pounds per hook on the mirror, and 10 pounds maximum per shelf level
for the organizer.
☞
Mounting the Products Directly to a Wall:
Before you get started, use a tape measure to measure out below distances on either of the products:
Distance A: Measure from the top edge of the product to one of the keyholes at the upper center position of the
keyhole notch.
Distance B: Measure between the two keyholes (from center to center of each keyhole).
1) Hold the mirror or the shelf organizer against wall at a desired location so that the rear side of the product
touches the wall directly. Use a level to ensure that the product is level and then use a pencil to draw a
slight line on the wall along the top edge of the product. Set the product aside.
2) Use a tape
measure and a pencil to make a “lower line” below the line of Step (1) that is spaced a distance
equal to “Distance A”. Use a level to ensure that the new created line is level (adjust if necessary).
3) At the lower line of Step (2), using the pencil and the tape measure to make two "insertion marks" centered
along this line that are spaced apart a distance equal to "Distance B". These are the insertion points for the
mounting hardware
4) The provided anchors cannot penetrate wood. Therefore we have to find out if either insertion mark of Step
(3) happens to align with a wall stud (use a stud-finder to determine this). If either does, do not use an
anchor at the mark. Instead, use a screwdriver to secure a provided screw directly into the wall at the mark.
Rotate the screw clockwise until the screw head resides about 3/8" from the wall.
5) For marks that do not align with a stud, install a provided anchor into the drywall first
and then the screw. To install the anchor, use the screwdriver to engage the anchor
and then position the anchor tip against the wall at the mark. Firmly push the anchor
into the wall as you rotate it clockwise. The anchor is designed to drive itself into the
wall as it is rotated. Continue rotating the anchor until the wide end of the anchor
becomes even with the wall surface. Do not over-tighten.
6) Use the screwdriver to secure a screw into each installed anchor. Rotate the screw
clockwise until the screw head reside
s about 3/8” from the wall.
7) Mount the
mirror or the shelf organizer
on the wall by fitting the large opening on each
keyhole to the protruding screw heads. Gently push down the item so that the screws
engage with the keyholes and lock it in place.
You may need to tighten or loosen the
screws a bit to allow the product to fit snugly against the wall.
The hardware included with this item is meant for
drywall or stud mounting only. If your wall is made
from another material such as concrete or plaster,
please consult your local hardware store for
assistance in selecting the correct hardware.
