2. Place slat roll on side rail ledges so the pre-drilled holes on the slat roll line up with the pre-drilled holes on the side
rail ledges. (binding should face UP). Attach the slats by inserting the Philips wood screws (E). Tighten with Phillips
screwdriver. Figure #2.
Note: If the floor is uneven, adjust the recessed levelers which are found pre-attached to the leg bottoms. Figure #3.
Using two people, carefully grasp one side of the daybed and elevate it slightly to provide access to levelers.
Turn the levelers until adequate contact will be made with the floor.
Carefully set the daybed down. Repeat until the daybed sits level and is stable.
Figure #2 Figure #3
3. Hold trundle front board upright and tilted slightly towards the faceplates of the pre-assembled bed frame. Figure #4.
Insert an (B) Allen bolt into (C) spring washer and (D) flat washer. Continue the screw through the hole in the
back of the trundle front board.
Repeat for all pre-drilled holes.
Tighten Allen bolts by using enclosed (A) Allen key. Periodically tighten all connections.
4. Assembly is complete. Figure #5.
Figure #4 Figure #5
Care Instructions:
•
To clean, wipe with a soft damp cloth.
•
Always avoid the use of chemical and abrasive cleaners.
•
Wipe spills immediately.
thank you for your purchase
stores | catalog | www.potterybarn.com
