New York Shoe Rack
Mounting instruction
Parts Included:
1)2 Wall Mounted Brackets (Part- A)
2)4 Iron rods ((Part- B)
Hardware Included:
1) 4 ITW Anchors (For Dry wall mounting)
2) 4 ITW Screws
3) 8 Allen Screws
4) 1 Allen key
Maximum total weight capacity for NEW YORK Shoe Rack is pounds (Kg).
Note: Assembly by two people recommended. Open the box safely and unpack
all the included items. Do not discard packing until assembly is completed.
Pre- assembly:
1)
Take out the 2 brackets (A) and 4 iron rods (B) for assembling the shoe rack.
2)
Place the Iron rod (B) on the wall mount bracket (A) as shown in illustration and
secure by tightening the Allen screw with the help of Allen key provided. Similarly
secure other 3 rods (B).
Dry Wall mounting:
1) Mark the location on the wall. These marks will be used to determine the location of
your mounting hardware.
2) Use a Phillips screw driver to insert the anchors. Do not
“push” or drive the anchors
into the wall as they are designed to bore into the wall like a drill bit. Slowly turn the
anchor clockwise while applying pressure until the flange just touches the wall.
3) Using a Phillips-head screw driver, drive the screws into wall anchors. The screws
should not be flush to the wall. Leave a gap of
¼” between the head of screw and the
wall
4) Hang the shoe rack on the screw heads. If it does not fit properly, you may need to
adjust the gap between the head of screw and the wall and hang again.
Wood Stud mounting:
1) Mark the location on the wall. These marks will be used to determine the location of
your mounting hardware.
2) Using a Phillips-head Screw driver, drive the screws into the wall at the desired
location.
The screws should not flush to the wall. Leave a gap of ¼” between the head of
screw and the wall.
2) Hang the shoe rack on the screw heads. If it does not fit properly, you may need to
adjust the gap between the head of screw and the wall, and hang again.
Assembly is complete.
