Hayden towel ring
Mounting Instructions
Hardware (Included):
ONE Screw
ONE Anchor
ONE Allen wrench
Tools Required:
Phillips Screwdriver, Pencil, Stud Finder
Parts Included:
ONE Mounting plate
(Used to attach the mounting bracket to the wall)
ONE Hex screw
(Used to secure the mounting bracket to the mounting plate)
ONE Towel ring
Mounting and Assembly Instructions:
1. Arrange the item as shown in the illustration below.
2. You will notice that the mounting plate is shaped like a small cup and includes a sharp point on one
side and a hole. Position the mounting plate into the large recess of the bracket so that the sharp
point faces away from the towel ring
and down (exactly at the 6 o’clock position). Use the provided
Allen wrench to tighten the small set screw located at the bottom of the mounting bracket to secure
the mounting plate firmly within the recess.
3. Hold the towel ring against the wall at a desired mounting location so that the mounting plate is
facing the wall (do not let the towel ring touch the wall yet). Firmly press the mounting bracket
against the wall so that the sharp projection of the mounting plate penetrates the soft drywall and
leaves one detent mark.
4. Use the Allen wrench to remove the mounting plate. Hold the mounting plate against the wall so
that the sharp point fits within the
marked detent and the hole of the plate resides at the 12 o’clock
position. Use a pencil to mark the wall through the hole of the plate. The resulting pencil mark is
the location for the hanging hardware.
5. The provided anchor cannot penetrate wood studs so we recommend that you use a stud-finder to
determine if either pencil mark of Step (4) aligns with a wall stud. If so, hold the mounting plate
against the wall so that the hole of the plate aligns with the pencil mark and the sharp point of the
plate is received into the detent mark formed in the wall and then use the screwdriver to install only
a screw through the hole and directly into the wall and stud. Rotate the screw clockwise until the
mounting plate is firmly secured to the wall.
6. For the pencil mark that does not align with a stud, use a Phillips screwdriver to install the provided
anchor into the wall at the mark. The anchor protects the drywall and is meant to receive the screw
after it is installed. Align the tip of the anchor at the mark and then use a screwdriver to push the
anchor into the wall as you rotate it clockwise. The anchor will drive itself into the wall like a screw.
Continue rotating until the wide end of the anchor becomes even with the wall.
7. Hold the mounting plate against the wall so that the hole aligns with the mark and the sharp point
of the plate is received into the detent mark formed in the wall and then use the screwdriver to
install a screw through the hole of the mounting plate and into the aligned and installed anchor.
Rotate the screw clockwise until the mounting plate is firmly secured to the wall.
The hardware included with this item is meant for
drywall or stud mounting only. If your walls are
made from concrete, brick or plaster, please
consult your local hardware store for assistance
in selecting the appropriate hardware.
