INSTALLATION MANUAL: PAD100-SM SPEAKER MODULE
Document 5406316-A 02/16
Potter Electric Signal Company, LLC • St. Louis, MO • Phone: (800) 325-3936 • www.pottersignal.com
PAGE 3 OF 3
Figure 5.
Example of Wiring a PAD100-SM as Class A Output Channel
Notes:
•
SLC wiring style supports the Class A, Class B and Class X.
•
Output channel wiring supports Class A or Class B wiring styles.
•
SLC loop wiring (SLC+, SLC-) are power limited.
•
Wiring for terminals SLC+, SLC- are supervised.
•
All wiring is between #12 (max.) and #22 (min.).
•
Wire Preparation – Strip all wires 1/4 inch from their edges as shown here:
– Stripping too much insulation may cause a ground fault.
– Stripping too little may cause a poor connection and subsequently an open circuit.
These instructions do not purport to cover all the details or variations in the equipment described, nor provide for
every possible contingency to be met in connection with installation, operation and maintenance.
Specifications subject to change without prior notification.
For Technical Assistance contact Potter Electric Signal Company at 866-956-1211.
Actual performance is based on proper application of the product by a qualified professional.
Should further information be desired or should particular problems arise, which are not covered sufficiently for
the purchaser's purpose, the matter should be referred to a distributor in your region.
1/4 inch
It is possible that the internal relay in the PAD100-SM may be shipped in the non-normal / activated state. To ensure
that the internal relay is set to the normal state, connect the module to the SLC loop and reset the control panel
before terminating the wiring to the module's output.
FROM FACP OR
PREVIOUS MODULE
TO NEXT MODULE
FROM AMPLIFIER 1
FROM AMPLIFIER 2
NOTE: END-OF-LINE RESISTOR NOT REQUIRED
PAD100-SM Class A Wiring
SP
SP
SP
firealarmresources.com