PostProcess Technologies, Inc. • www.postprocess.com • REV C | page 5
1. OPERATION
1.1 Connecting Power to the RADOR
The
RADOR
is delivered with an industrial power cord. Use only the power cord supplied by
POSTPROCESS
with
the
RADOR
. Connect the
RADOR
only to 60 hz single-phase 120v power.
The
MASTER POWER SWITCH
is located on the lower left rear panel of the
RADOR
. Before connecting or
disconnecting the
RADOR
to power, ensure the
MASTER POWER SWITCH
is in the bottom “O” or
OFF
position
(refer to
Figure 1. Location of Master Power Switch
).
When the power cord is connected to the
RADOR
and plugged into a 60 hz single-phase 120v power outlet, press
the
POWER
switch to the “I” or
ON
position. The
RADOR
is now ready to be powered up.
WARNING
Do not place the power cord in a location where it could come into contact with water or other liquid substances.
It is recommended to keep the entire power cord suspended above the floor surface.
Figure 1. Location of Master Power Switch
Figure 2. Power and Emergency Stop Buttons
1.1.1 Powering Up the RADOR
The
POWER
button for the
RADOR
is located to the left of the right side access panel, below the handle. To power
up (or down) the
RADOR
, press the
POWER
button. If the
POWER
button is flashing, the
RADOR
is on and ready
for use. The
POWER
button will be continuously lit when the
RADOR
is running. (refer to
Figure 2. Power and
Emergency Stop Buttons
).
