iQ200 User’s Manual Chapter 2: Setup and Use
16
Figure 2-15 Lift the Handle
3.
Thread the folded label through the media slot at the rear end of the printer, and go on to thread
the media under the Media Guide Rod, over and pass the Platen Roller to the front of the
printer.
4.
Slide the Media Guides to the edge of the media, making sure that the media remains flat and is
placed in the middle of the Tear-off Bar. This can be checked with the ruler on the Tear-off Bar.
See Figure 2-16.
Figure 2-16 Thread the Media through Media Slot
5.
Press down the Handle of the Printhead to lock the Printhead, then close the right cover. See
Figure 2-17.