Laser Safety
The laser scanner complies with safety standard IEC 60825 -1for a Class I laser
produce. It also complies with CDRH as applicable to a Class IIa laser product.
Avoid long term staring into direct laser light.
Radiant Energy: The laser scanner uses one low-power visible laser diodes
operating at 650nm in an opto-mechanical scanner resulting in less than 3.9
μ
W
radiated power as observed through a 7mm aperture and averaged over 10
seconds.
Do not attempt to remove the protective housing of the scanner, as unscanned
laser light with a peak output up to 0.8mW would be accessible inside.
Laser Light Viewing: The scan window is the only aperture through which laser
light may be observed from this product. A failure of the scanner motor, while
the laser diode continues to emit a laser beam, may cause emission levels to
exceed those for safe operation. The scanner has safeguards to prevent this
occurrence. If, however, a stationary laser beam is emitted, the failing scanner
should be disconnected from its power source immediately.
Adjustments: Do not attempt any adjustments or alteration of this product.
Do not remove the protective housing of the scanner. There are no
user-serviceable parts inside.
Caution: Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous laser light exposure.
Optical: The use of optical instruments with this product will increase the eye
hazard. Optical instruments include binoculars, magnifying glasses, and
microscopes but do not include normal eye glasses worn by the user.
ii
