BRX Power Injector Installation Guide
17
180-0192-001-R01
3.3 Using Bypass Section for POTS pairs
The POTS Bypass section of the BRX Power Injector allows you to combine POTS pairs and BRX
Power pairs inside cable binders in the absence of a nearby cross-connect. These cable binders can
then directly connect to the POTS port(s) of the DSLAM.
Step 1:
insert the cable binders with the POTS
pairs into the second from the left connector. As
per the installation of the AC Power Cable,
remove the rubber grommet and cut an opening
large enough to insert one or two cable binder
(as needed).
You can also insert the cable binders that will
convey the POTS pairs and the BRX Power
pairs in the same fashion. Use the rightmost
opening for this.
Step 2:
select the POTS pairs from the first (1
st
)
cable binder and secure them in the left bank of
punch-down blocks.
