4 - 4
4. Using printer power adaptor
for PD2200B series
The PD2200B series can also be powered by the power adaptor
supporting a Posiflex POS printer by using a separately purchased specific
power cable (P/N: 20863250900). Follow steps below:
1. Check that the (+24 V DC) power adaptor plug matches the power
socket. But please always keep the insertion of the power adaptor into
the power socket as the very last step of the whole installation
procedure.
2. Insert the 3 pin power connector from the +24 V DC power adaptor to
the “+24 V DC In” jack in the connector area. Be sure to hear a click
to obtain a firm contact.
3. Insert either end of the power cable (20863250900) to “+24 V DC
Out” jack in the connector area and insert the other end to the power
connector of Posiflex POS printer if needed. Be sure to hear a click at
each connection to obtain a firm contact.
4. Now place the base on a horizontal surface and prepare to power on.
5. Please note that when DC power connection is used, there
must be no
AC power connection at the bottom of the base cabinet on the PD2200.
C. After Powering Up
A firmware version as power on sign will appear for a while and the
emulation mode will appear for a while after the firmware version display. Then
a blinking block-shaped cursor will appear at the left-most digit of the top row
for Noritake or Futaba emulation mode and no cursor will appear for other
emulation modes. The installation is now completed.
Posiflex POS
Printer Power
Adaptor (24 V DC)
PD2200B
Posiflex POS printer
+24 V DC
+24 V DC Out
+24 V DC In
Power Cable
