8
10.
You can measure and add further ingredients during
operation through the small opening in the lid, using the
removable measuring cup with 65 ml filling volume.
11.
Let the motor wind down completely before removing the
Blender Jar. Never remove it from the base while the Blender
is still in operation or while the motor is still running.
12.
If you are finished using the Blender, unplug the device and
clean the Jar and individual parts.
SECURITY INSTRUCTIONS WHEN USING WITH HOT
LIQUIDS
Be careful when adding and mixing hot ingredients or removing
the lid from the Blender Jar. Steam might escape unexpectedly.
Never use this device to process boiling liquids.
Start operating the Blender at low speeds and slowly raise the
speed until you reach the desired speed.
Always firmly close the lid included in delivery to prevent contents,
hot liquids, and hot steam from escaping.
USING THE TAMPER
Remove the measuring cup from the lid and hold the plunger to the
lid opening.
The plunger is only intended to press ingredients towards the blades.
CLEANING AND MAINTENANCE
The Jar should be cleaned and dried as follows after each use.
Not (properly) cleaning the high-performance Blender might
impair its functionality.
1.
Before cleaning, power off the device and disconnect the plug
from the connector.
2.
Never dunk the housing of the motor base into water.
3.
Do not use scratching or abrasive cleaning agents.
4.
Only wipe off the housing with a moist cloth.
5.
Do not attempt to remove the cutting blades from the Blender
Jar in order to clean them. This might cause the Blender Jar
to leak.
