POS-X XR-200, Технические характеристики товара

Страница: 4 / 17

Page 3
Self Test
While pressing the paper feed switch for more than 10 seconds after the printer in
turned on, the self test mode is initiated. The printer self test includes a listing of
the current default settings, read and write test of internal RAM, checksum test of
internal program memory, loop back detection statement, a staggered dot line, a
few lines of rotating character set, and a diagnostic report. The printer then enters
into the On-Line mode.
Configuration Setup
When the paper FEED switch is pressed and released instantly as the power is
applied to the printer, the printer will print the current printer configuration settings
along with the DIP switch information. If the printer setup needs to be changed,
turn the Power Off before changing the setting.
The printer will be setup at the factory as follows;
Printer is setup as follows:
Model: XR-200
Firmware: Ver X.XX
Loopback: Not Detected(DSR)
Interface: Serial
Emulation: Epson TM-U200
CR Character: CR=CR only
Flow Control: DTR/DSR
Data Bits: 8 Bits
Parity: None
Baud Rate: 9600
CPL: 40/33 Char/Line
Two Color: Installed
Auto Cutter: Installed
Paper :
Roll Type