Troubleshooting
WADE-8013/WADE-8014 User’s Manual
5-1
Chapter 5
Troubleshooting
This chapter provides a few useful tips to quickly get WADE-8013/WADE-8014
running with success. As basic hardware installation has been addressed in Chapter
2, this chapter will primarily focus on system integration issues, in terms of BIOS
setting, and OS diagnostics.
5.1
Hardware Quick Installation
ATX Power Setting
Unlike other Single board computer, WADE-8013/WADE-8014 supports ATX only.
Therefore, there is no other setting that really needs to be set up. However, there are
only two connectors that must be connected—J22 (4 pins CPU +12V main power
connector) & J15 (24 pins ATX Power Connector) Figure.
Serial ATA Hard Disk Setting for IDE/AHCI/RAID
Unlike IDE bus, each Serial ATA channel can only connect to one SATA hard disk at a
time; there are total four connectors, J17, J18, J23, and J24. The installation of Serial
ATA is simpler and easier than IDE, because SATA hard disk doesn’t require setting
up Master and Slave, which can reduce mistake of hardware installation. All you
need to operate IDE or AHCI or RAID application for system, please follow up
setting guide in BIOS programming (Table 5-1); Furthermore, you can consult chapter
4.3 Configuration “SATA Configuration” part of the” SATA Mode”.
