METHOD 1
:
1.
Select a previously programmed channel on the display
.
2.
Press P2, the motor will make a single beep sound and move briefly up and
down
.
3.
Press STOP, the motor will make a single beep sound
.
4.
Press P2 again, you will hear 4 beeps and the roller shutter will move briefly up
and down
.
METHOD 2
:
Using the microswitch located on the lead
emerging from the lead of the drive
, you
can delete a previously programmed transmitter channel. To do so, you should
:
1.
Press the microswitch down for at least 15 seconds
.
2.
After 1 second, the motor will make a short beep sound and move up and down,
whereas after the next 5 seconds, the motor will confirm with 3 beeps and the roller
shutter will move UP and DOWN twice, and finally after 15 seconds the motor will
make 3 beeps and the roller shutter will move UP and DOWN once
.
METHOD
3:
Reprogramming the radio drive on a given channel (
point
1
of this manual
)
automatically deletes previous settings
.
4
IMPORTANT!!!
If you delete
the
settings
of a particular channel
, drives assigned to th
at
channel
will be completely deleted from other channels
as well.
min. 15 seconds
4. Channel deletion (deleting all channel settings).
