Page 9
For technical questions, please call 1-888-866-5797.
Item 62469
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM FLyING DEBRIS:
Wear long pants, long sleeves and protective footwear. Wear ANSI-approved safety goggles, dust mask,
hearing protectors, and gloves.
DO NOT USE VAcUUM WITHOUT cOLLEcTION BAG ATTAcHED.
connecting Extension cord
Table A: REcOMMENDED MINIMUM WIRE GAUGE
FOR EXTENSION cORDS (120 VOLT)
NAMEpLATE
AMpERES
(at full load)
EXTENSION cORD
LENGTH
25′
50′ 100′ 150′
0 – 6
18
16
16
14
6.1 – 10
18
16
14
12
10.1 – 12
16
16
14
12
12.1 – 16
14
12
Do not use.
1. USE PROPER EXTENSION CORD.
Make sure your extension cord is in good
condition. When using an extension cord, be
sure to use one heavy enough to carry the
current your product will draw. An undersized
cord will cause a drop in line voltage resulting in
loss of power and overheating.
Table A shows
the correct size to use depending on cord
length and nameplate ampere rating.
If in doubt, use the next heavier gauge.
The smaller the gauge number, the heavier the cord.
Note;
The Power Switch has three settings:
•
Off
- Slide switch down to bottom position.
•
Low
- Slide switch to middle position.
•
High
- Slide switch up to top position.
O
1
2
1
Off
Low
High
2. Make sure Power Switch is in Off (O) position.
3. Connect extension cord to plug on back of unit.
4. Route extension cord around Cord Retainer.
cord
Retainer
Extension
cord
Figure K
5. Route extension cord along a safe route to reach
the work area without creating a tripping hazard.
6. Plug Extension Cord into an
120V GFCI power outlet.
