10 |
P a g e
3.
To enable the remote control to function the power to the fireplace
must be switched on.
4.
At a distance of 5 to 6 feet, point the remote control directly towards
the bottom right hand side of the fireplace. (
Figure 9
)
B On/Off Switch: Press on/off switch to turn fire on.
C Flame Effect Dimmer: To operate press once to commence dimming
cycle. During the dimming cycle the fire will slowly dim then brighten
allowing user to choose suitable level. Press a second time to stop cycle
when the desired brightness level is obtained. Failure to press dimmer a
second time will result in the fire dimming then brightening repeatedly
.
D Heater Low Heat (750 W) Press this once to switch to high heat. The
indicator light will come on as well as the fan. Press again to turn off. (The
fan will continue to run for a few moments until sensors indicate cool
condition).
E Heater Maximum Heat (1500 W) Press this once to switch to high
heat. The indicator light will come on as well as the fan. Press again
to turn off. (The fan will continue to run for a few moments until
sensors indicate cool condition).
F Indicator Lamps will verify current activity. If you are unsure if heat
is on or off check the lamps on the control panel. If the function is on
the indicator lamp will light above the function switch.
