4
ASSEMBLY INSTRUCTIONS
CAUTION:
The lamp fixture is designed to be mounted so that the motion detector controls face toward the ground.
If the lamp fixture is mounted in any other position, it may be possible for water to enter the unit and cause damage
to the unit and cause possible electric shock. Make sure the controls are facing toward the ground!
Your installation in now complete. Turn on power at the circuit breaker and flip the wall switch to the ON position. The
wall switch must remain in the ON position for the motion detector to operate properly.
Hardware Used
Hardware Used
DD
BB
Wire Nut
Decorative Nut
x 3
x 2
4. Attach the black supply wire to the black fixture wire and the white supply wire to the
white fixture wire using wire nuts (BB). Connect the fixture ground wire and the supply
ground wire together using a wire nut (BB). Wrap all wire connections with electrical
tape (not included) for a more secure connection. Note: If you have electrical ques-
tions, consult your local electrical code for approved grounding methods.
5. Make sure wire connections are secure. Carefully position wires and wire nuts (BB)
into the junction box. Place the wall plate back onto the fixture mounting screws, and
secure it into place using the decorative nuts (DD).
Hardware Used
CC
AA
Mounting Screw
Crossbar
x 2
x 1
3. Remove the crossbar (CC) and two decorative nuts (DD) from back plate. Save deco-
rative nuts (DD) for later. Attach the crossbar (CC) to the junction box (not included)
with the mounting screws (AA).
3
CC
AA
4
BB
5
DD
Lowes.com/portfolio
IMPORTANT:
After mounting the fixture, it will be necessary to apply silicone sealant caulking compound (not included)
to the perimeter of the fixture where the back of the cover plate meets the mounting surface. Silicone caulking prevents
water from entering the junction box.
