7
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
In motion sensing mode,
the light does not turn on
when there is motion.
In motion sensing mode,
the light stays on
continuously.
The light comes on for
no apparent reason.
1. Wall switch or circuit breaker is off.
1. Turn on switch or circuit breaker.
2. Test the light bulb in a known working
light fixture. Replace light bulb.
3. Tighten light bulb in socket.
4. Check wire connections.
5. Relocate fixture away from a
western facing wall.
6. Eliminate or turn off other light source.
OR
Block other light source from
shining onto photocell sensor.
OR
Relocate fixture.
7. Relocate fixture to a lower
position or to a different location.
Eliminate heat source.
OR
Relocate fixture.
1. Lower the sensitivity.
2. Light bulb may be dead.
5. Too much sunlight is shining onto
photocell sensor in the early evening.
6. Too much light is shining onto
photocell sensor due to another light
source, such as a street lamp or other
light fixture.
7. Moving persons or vehicles are below
the view of the motion sensor, because
motion sensor is mounted too high.
False triggering caused by a heat source,
such as a heater or dryer vent or heated
swimming pool.
1. Street or sidewalk traffic is triggering
the motion sensor.
2. Eliminate heat source.
OR
Relocate fixture.
2. False triggering cause by a heat source,
such as a heater or dryer vent or heated
swimming pool.
3. Light bulb is loose.
4. Incorrect or loose wire connections.
WARRANTY
● Instructions shall caution users that modifications not approved by the party responsible for compliance could void
user’s authority to operate the equipment.
● NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures: Reorient or relocate the equipment into an outlet on a circuit different from that
to which the receiver is connected; or consult the dealer or an experienced radio/TV technician for help.
In motion sensing mode,
the light always on during
the daytime or evening
Turn off the wall switch, wait
10 seconds or longer, before turning
the wall switch on again.
Setting problem.
The light comes on
during the daytime or
too early in the evening.
Relocate fixture.
The fixture may be installed in a shaded
area, such as under a porch or eave,
preventing daylight from shining onto
the photocell sensor.
Page 7/Inside Spread
