After
the
cooktop cools
the
´t`
displays
will
be
erased
and
the
cooktop
control enters standby
mode. This means that the user can reactivate the
appliance by touching
.
Residual Heat Functions
.
After the cooktop is turned off when cooking is finished, there is some heat
stored in the vitroceramic glass called residual heat. The cooktop can calculate
roughly how hot the glass is. If the calculated temperature is higher than
+ 60 ° C, the corresponding zone
display will flash an ´H` symbol. The
residual heat display is shown as long as the calculated heater temperature
is higher than + 60 ° C.
.
The display of the residual heat has the lowest priority and is overwritten
by every other display value such as safety turn off's and displaying error
co de s.
.
COOKTOP RESET
.
When the cooktop
is first
turned
on
after
installation
or
after
a
power
outage
during operation, the cooktop will display a flashing ´H` on all or some zone
displays.
.
Which displays flash an ´H` depends on mode of operation when the power
outage happened.
This is due to the cooktop retaining zone heat information in its memory, this
is not a fault and is normal.
.
To reset the Hob, press and hold the top left zone , bottom left zone and
the buttons at the same time for roughly 2 seconds.
hold these buttons
to reset the Hob.
13